Chemical
Chemical
KS 1821:2005
Plastic monobloc chairs - Specification.
Sets out requirements for the evaluation and selection of plastic monobloc chairs for adults..
Kes 5,716.00
KS 2454:2013
Plastic tableware- Specification
Specifies the requirements for melamine type plastic-ware suitable for use in homes, mess halls, hospitals, and for other similar service...
Kes 3,862.00
KS ISO 527-1:2019
Plastics Determination of tensile properties pt 1:General principles
specifies the general principles for determining the tensile properties of plastics and plastic composites under defined conditions...
Kes 3,605.00
KS ISO 527-2: 2012
Plastics Determination of tensile properties pt 2:Test conditions for moulding and extrusion plastics
specifies the test conditions for determining the tensile properties of moulding and extrusion plastics, based upon the general principles given in ISO 527.1...
Kes 3,038.00
KS ISO 182-1: 1990
Plastics Determination of the tendency of compounds and products based on Vinyl chloride homopolymers and copolymers to evolve hydrogen chloride and other acidic products at elevated temperature
Specifies a method for the determination of the thermal stability at elevated temperature of compounds and products based on Vinyl chloride homopolymers and copolymers (in the following text abbreviated to PVC) which undergo dehydrochlorination ..
Kes 2,163.00
KS ISO 844: 2014
Plastics Rigid cellular plastics Determination of compression properties.
Specifies a method of determining: a) the compressive strength and corresponding relative deformation, or b) the compressive stress at 10 % relative deformation, and c) when desired, the compressive modulus of rigid cellular plastics...
Kes 3,038.00
KS ISO 1043-1: 2011
Plastics Symbols and abbreviated terms pt 1 :Basic polymers and their special characteristics
defines abbreviated terms for the basic polymers used in plastics, symbols for components of these terms, and symbols for special characteristics of plastics...
Kes 3,167.00
KS ISO 1043-2:2011
Plastics Symbols and abbreviated terms pt 2: Fillers and reinforcing materials
specifies uniform symbols for terms referring to fillers and reinforcing materials...
Kes 2,163.00
KS ISO 1043-4: 1998
Plastics Symbols and abbreviated terms pt 4:Flame retardants
provides uniform symbols for flame retardants added to plastics materials...
Kes 2,163.00
KS ISO 306: 2013
Plastics Thermoplastic materials Determination of Vicat softening point (VST).
Specifies four methods for the determination of the Vicat softening temperature (VST) of thermoplastic materials...
Kes 3,308.00