Mechanical

Mechanical Engineering



KS ISO 10286:2015

Gas cylinders - Terminology

Gives the terminology for ISO/TC 58 standards intended to be used under regulations for the transport of dangerous goods that are based on the UN Model Regulations...

Kes 4,696.00

KS ISO 11117:1998

Gas cylinders - Valve protection caps and valve guards for industrial and medical gas cylinders - Design, construction and tests.

Specifies the requirements for valve protection caps and guards, intended for use with industrial and medical gas cylinders..

Kes 3,038.00

KS ISO 21172-1:2015

Gas cylinders - Welded steel pressuredrums up to 3 000 litres capacity forthe transport of gases - Design and construction Part 1: Capacities up to 1 000 litres.

Specifies the minimum requirements for the material, design, fabrication, construction and workmanship, inspection, and testing at manufacture of refillable welded steel gas pressure drums, hereafter referred to as drums, of volumes 150 l to 1 000 ..

Kes 5,562.00

KS ISO 32:1977

Gas cylinders for medical use - Marking for identification of content.

Establishes a system of marking and a series of colours for the identification of the content of gas cylinders intended for medical use only..

Kes 1,854.00

KS ISO 11114-2:2013

Gas cylinders-Compatibility of cylinder and valve materials with gas contents Part 2: Non-Metallic materials

Gives guidance in the selection of compatibility between non-metallic materials for gas cylinders and valves and the gas contents...

Kes 3,167.00

KS ISO 13341:2010

Gas cylinders-Fitting of valves to gas cylinders

Specifies the procedures to be followed when connecting cylinder valves to gas cylinders...

Kes 2,884.00

KS ISO 25760:2009

Gas cylinders-Operational procedures for the save removal of valves from gas cylinders

Intended for suppliers, operators in testing facilities, operators performing cylinder maintenance and any person authorized to remove valves from gas cylinders...

Kes 3,308.00

KS ISO 11119-3:2013

Gas cylinders-Refillable composite gas cylinders and tubes Part 3: Fully wrapped fibre reinforced composite gas cylinders and tubes up to 450 L with non-load-sharing metallin or non-metallic li

Gives guidance in the selection and evaluation of compatibility between non-metallic materials for gas cylinders and valves and the gas conctents...

Kes 3,167.00

KS 9-4:2018

Gas cylinders-Refillable welded low carbon steel cylinders for liquefied petroleum gas (LPG) exceeding 1.5 litre water capacity Part 4:Requalification and inspection.

Specifies the interval, inspection and testing procedures for requalification of refillable welded low carbon steel LPG cylinders of water capacity exceeding 1.5 L and up to including 150 L...

Kes 3,038.00

KS ISO 18172-1:2007

Gas cylinders-Refillable welded stainless steel cylinders Part 1:Test pressure 6Mpa and below

Specifies minimum requirements concerning material, design, construction and workmanship, manufacturing processes and testing of refillable transportable welded stainless steel gas cylinders, of water capacities from 0,5 l up to and including 500 l, ..

Kes 3,862.00

Showing 311 to 320 of 841 (85 Pages)