Civil
Civil Engineering
KS 1238-12:2003
Methods of test for aggregates - Part 12: Methods for determination of ten per cent fines value.
Describes methods for the determination of the ten per cent fines value (TFV) of aggregates which gives a relative measure of the resistance of an aggregate to crushing under gradually applied compressive load..
Kes 3,167.00
KS 1238-13:2003
Methods of test for aggregates - Part 13: Methods for determination of aggregate impact value (AIV).
Describes methods for the determination of the aggregate impact value (AIV) which give a relative measure of the resistance of an aggregate to sudden shock or impact..
Kes 3,167.00
KS 1238-14:2003
Methods of test for aggregates - Part 14: Methods for determination of aggregate absrasion value (AAV).
Describes a method for the determination of the aggregate abrasion value (AAV) which gives a measure of the resistance of aggregate to surface wear by abrasion..
Kes 2,884.00
KS 1238-15:2003
Methods of test for aggregates - Part 15: Methods for determination of polished stone value (PSV).
Describes the method for determining the polished-stone value (PSV) of an aggregate..
Kes 3,308.00
KS 1238-16:2003
Methods of test for aggregates - Part 16: Methods for determination of the water-soluble chloride salt content of aggregate.
Describes the method for determination of the water-soluble chloride salt content of aggregate..
Kes 3,167.00
KS 1238-17:2003
Methods of test for aggregates - Part 17: Methods for determination of sulphate content.
Describes two methods for determining the sulphate content of aggregates..
Kes 3,308.00
KS 1238-18:2003
Methods of test for aggregates - Part 18: Methods for determination of acid-soluble material in fine aggregate.
Describes a method for determining amount of acid-soluble material in both of the size fractions of fine aggregate, all passing a 5.00 mm test sieve, separated by sieving on a 600 test sieve..
Kes 2,884.00
KS 1238-19:2003
Methods of test for aggregates - Part 19: Methods for testing and classifying the drying shrinkage of aggregates in concrete.
Describes the method for classifying the drying shrinkage of aggregates for use in concrete..
Kes 3,038.00
KS 1238-1:2003
Methods of test for aggregates - Part 1: General requirements for apparatus and calibration.
Gives definitions and symbols and specifies common equipment and calibration procedures for the KS 1238 series..
Kes 3,167.00
KS 1238-20:2003
Methods of test for aggregates - Part 20: Methods for the determination of soundness.
Describes the method for determining the soundness of aggregates by subjecting the aggregate to cycles of immersion in a saturated solution of magnesium sulphate followed by oven-drying..
Kes 3,167.00