Mechanical
Mechanical Engineering
KS ISO 11119-3:2013
Gas cylinders-Refillable composite gas cylinders and tubes Part 3: Fully wrapped fibre reinforced composite gas cylinders and tubes up to 450 L with non-load-sharing metallin or non-metallic li
Gives guidance in the selection and evaluation of compatibility between non-metallic materials for gas cylinders and valves and the gas conctents...
Kes 3,167.00
KS 9-4:2018
Gas cylinders-Refillable welded low carbon steel cylinders for liquefied petroleum gas (LPG) exceeding 1.5 litre water capacity Part 4:Requalification and inspection.
Specifies the interval, inspection and testing procedures for requalification of refillable welded low carbon steel LPG cylinders of water capacity exceeding 1.5 L and up to including 150 L...
Kes 3,038.00
KS ISO 18172-1:2007
Gas cylinders-Refillable welded stainless steel cylinders Part 1:Test pressure 6Mpa and below
Specifies minimum requirements concerning material, design, construction and workmanship, manufacturing processes and testing of refillable transportable welded stainless steel gas cylinders, of water capacities from 0,5 l up to and including 500 l, ..
Kes 3,862.00
KS ISO 18172-2:2007
Gas cylinders-Refillable welded stainless steel cylinders Part 2: Test pressure greater than 6M pa
Specifies minimum requirements concerning material, design, construction and workmanship, manufacturing processes and testing of refillable transportable welded stainless steel gas cylinders, of water capacities from 0,5 l up to and including150 l, f..
Kes 3,862.00
KS ISO 4706:2023
Gas cylinders-Refillable welded steel cylinders-Test pressure 60 bar and below.
Specifies the minimum requirements concerning material selection, design, construction and workmanship, procedure, and test at manufacture of refillable welded-steel gas cylinders of water capacities from 0,5 l up to and including 150 l and drums..
Kes 3,862.00
KS ISO 22991:2004
Gas cylinders-Transportable refillable welded steel cylinders for liquefied petroleum gas (LPG)-Design and construction.
Specifies minimum requirements concerning material, design, construction and workmanship, procedure and test at manufacture of transportable refillable welded steel liquefied petroleum gas (LPG) cylinders of water capacity up to and including 150 l..
Kes 3,708.00
KS 1959:2006
Gas lamp - Specification.
Specifies the requirements and tests for gas lamp intended for domestic use with LPG..
Kes 2,884.00
KS 1440:2005
Gas ovens - Domestic gas ovens for use with liquified petroleum gas - Specification.
Specifies construction, operation, safety requirements and test for domestic ovens of capacity not exceeding 0.1 m3 intended for use with liquified petroleum gas at 30 gf/cmas inlet pressure..
Kes 3,437.00
KS ISO 5171:2009
Gas welding equipment - Pressure gauges used in welding, cutting and allied processes.
Specifies requirements for Bourdon-tube pressure gauges normally used with compressed gas systems at pressures up to 30 MPa (300 bar) in welding, cutting and allied processes..
Kes 3,167.00
KS ISO 2503:2009
Gas welding equipment - pressure regulators and pressure regulators with flow-metering devices for gas cylinders used in welding, cutting and allied processes up to 300 bar (30 MPa).
Specifies requirements for single or two-stage pressure regulators without flow-metering devices for connection to gas cylinders used, welding, cutting and allied processes..
Kes 3,708.00