Civil
Civil Engineering
KS 750-6:1986
Methods of test for bitumen and bituminous products - Part 6: Loss of heating of bitumen and flux oil.
Determines the loss on heating of bitumen and of flux oil when heated under the conditions specified..
Kes 2,472.00
KS 750-4:1986
Methods of test for bitumens and bituminous products - Part 4: Solubility of bituminous binders.
Applies to bituminous binder containing not less than 9500 of bitumen in which volatile constituents will not normally be present. If water is present the amount is usually small, and should be removed as directed in the method..
Kes 2,163.00
KS 1746:2002
Methods of test for cold applied joint sealants for concrete pavements (polymer based with a curing agent).
Describes methods of test for cold applied joint sealants for use in joint roads, airfields and other exposed concrete pavements..
Kes 3,708.00
KS 982-10:1990
Methods of test for determination of physical and mechanical properties of wood - Part 10: Resistance to impact identation.
Specifies a method for determining the resistance of wood to impact identation..
Kes 2,163.00
KS 982-12:1990
Methods of test for determination of physical and mechanical properties of wood - Part 12: Sampling and general requirements.
Specifies methods for the selective and mechanical sampling of wood, for the conditioning of selected material and for the preparation of test pieces. In addition, it specifies the general requirements for physical and mechanical tests on small, clea..
Kes 3,038.00
KS 982-3:1990
Methods of test for determination of physical and mechanical properties of wood - Part 3: Testing in compression perpendicular to grain.
Specifies a method of testing wood in compression perpendicular to the grain to determine the proportional limit (conventional ultimate strength), the load being applied to the surface (radial or tangential) of the test piece..
Kes 2,472.00
KS 982-6:1990
Methods of test for determination of physical and mechanical properties of wood - Part 6: Ultimate shearing stress parallel to grain.
Specifies a method for determining the ultimate shearing stress of wood by compressive loading parallel to grain either along the radial or along the tangential surface..
Kes 2,163.00
KS 982-8:1990
Methods of test for determination of physical and mechanical properties of wood - Part 8: Modulus of elasticity in static bending.
Specifies a method for determining the modulus of elasticity of wood in static bending by measuring the deflection in the net bending area..
Kes 2,472.00
KS 982-1:1990
Methods of test for determining of physical and mechanical properties of wood - Part 1: Moisture content.
Specifies the method for determining the moisture content of wood for physical and mechanical tests..
Kes 2,472.00
KS 982-2:1990
Methods of test for determining of physical and mechanical properties of wood - Part 2: Density.
Specifies a method for determining the density (ratio of mass to volume) of wood for physical and mechanical tests both at the moisture content at the time of test and in the absolutely dry condition as well as the conventional density (ration of mas..
Kes 2,472.00