Chemical
Chemical
KS 1985-4:2007
Marine paints - Specification - Part 4: Two pack epoxy enamel.
Prescribes the requirements and test methods for two pack epoxy enamel - marine paint, used as a finish coat for the painting of steel plant equipment where protection against corrosion due to salty water, chemicals, mineral oils, solvents and resist..
Kes 2,472.00
KS 1985-5:2007
Marine paints - Specification - Part 5: Waterborne primer for galvanized, zinc / aluminium alloy-coated.
Specifies the requirements of waterborne primer intended to be used on primed or unprimed galvanized, zinc / aluminium alloy-coated steel in exterior, industrial or marine applications..
Kes 2,472.00
KS 1985-6:2007
Marine paints - Specification - Part 6: Two-pack full gloss polyurethanemarine paint.
Prescribes the requirements and test methods, for two component, solvent-borne, full gloss polyurethane paints..
Kes 2,472.00
KS 1985-7:2007
Marine paints - Specification - Part 7: Etch primers (Single pack and two-pack).
Prescribes the requirements and test methods, for single pack etch primers and two-pack intended for pre-treating metal surfaces to improve the adhesion of paint system applied to them..
Kes 2,472.00
KS 1985-8:2007
Marine paints - Specification - Part 8: Non-slip deck paint.
Prescribes the requirements and test methods for ready-mix non-slip deck paint..
Kes 2,472.00
KS 1993:2014
Marking pens for text highlighting -Specification
Standard specifies the constructional and performance requirements for marking pens used for text highlighting..
Kes 3,308.00
KS 1998:2014
Marking pens for writing and drawing Specification
specifies the constructional and performance requirements for marking pens for writing and drawing...
Kes 3,167.00
KS 25:2008
Matches Specification (Third Edition).
Prescribes the requirements and methods of test for matches...
Kes 3,167.00
KS ISO 8442-3:1997
Materials and articles in contact with foodstuffs - Cutlery and table hollowware - Part 3: Requirements for silver-plated table and decorative holloware.
Specifies material and performance requirements and test methods for silver-plated table and decorative holloware made principally from metals, and intended for use or upon the dining table..
Kes 3,308.00
KS ISO 8442-5:2004
Materials and articles in contact with foodstuffs - Cutlery and table hollowware - Part 5: Specification for sharpness and edge retention test of cutlery.
Specifies the sharpness and edge retention of knives which are produced for professional and domestic use in the preparation of food of all kinds, especially those knives intended for hand use..
Kes 3,167.00